Need metal roof installation in Onalaska? We come look first, tell you plainly what it needs, and put the price in writing before anything starts.
A metal roof is what Roofing Brothers is known for, and it has been since 2002. On a Onalaska home that means standing seam or exposed fastener panels set over sound decking and real underlayment, with the ridge, valley and eave trim cut and fit on site rather than forced out of a box.
Our metal roof installation work in Onalaska is handled by crews who do this every week, not by whoever happened to be free that morning. It shows up in the details — valleys, chimney flashing, eave and ridge closures — because that is where roofs actually leak.
We schedule your Onalaska metal roof installation for a stretch of dry weather, keep the job site picked up as we go, and do not leave a roof open overnight. When it is done the tear off is hauled away and a magnet goes over the drive.
The order we work in, and why each step matters more than it looks.
Nothing gets ordered until you have a written price in hand and have settled on the color you actually want.
Where the decking is sound and there is only one layer, we can often go over the top on purlins. We tell you which one your house calls for.
Synthetic underlayment over the whole roof, ice and water shield in the valleys and at the eaves, then panels set square on the correct fastener spacing.
Then the yard gets picked up, the scrap gets hauled off, and a magnet goes over the drive before we pull out.
What comes up on just about every estimate for a job like this.
Much less than people expect. Over solid decking with underlayment, a Onalaska metal roof sounds about like a shingle roof from inside. The loud tin roof people remember was screwed to open purlins on a barn.
Around twenty standard colors. Green, burgundy, bronze, black, gray, tan and barn red are the ones most Onalaska homeowners land on. We bring the chart with the estimate so you can hold it against your siding.
Installed properly over sound decking, a metal roof should give a Onalaska home 40 to 60 years. Standing seam often goes longer because there are no exposed fasteners to work loose or leak.
A straightforward Onalaska house is usually three to five days. A cut up roof with dormers, valleys and multiple pitches takes longer, because every panel and trim piece gets measured and fit on site.
Real feedback from homeowners we have worked for.
"Honest people. I asked for a quote on a whole new roof and they told me mine had another eight years in it and just needed the valleys resealed. Who does that anymore?"
"Green metal over the whole house and the carport. Looks sharp, and it is quiet inside when it rains, which honestly surprised me."
"Nice work on the roof and good communication throughout. I would have liked a little more warning about the dumpster arriving, but that is a small thing."